Bubbles On Wood Siding

Then remove the clamp and wax paper and lightly sand and refinish the surface.

Bubbles on wood siding.

Heat blistering caused by painting in direct sunlight on a surface that is too warm. Moisture blistering can be caused by the migration of water through an interior wall to the exterior thus pushing the paint off of the surface. Cover the repair with wax paper and a flat wood block then clamp the blister flat. This problem is far more common when paint is applied to a hot surface.

If scraping alone is enough the initial. You don t say specifically whether just scraping off the bubbles reveals bare wood or whether the old paint stays intact until the painter sands it off. Not very easy to see right away. The best remedy is to scrape and repaint the siding during a warm dry period so the moisture can come out of the wood and prevent future bubbles from appearing.

I can see how with the direction of the sun the color of the siding and the reflection from the low e glass the siding could bubble up a bit. Prevent new blisters by applying two coats of varnish or hand rubbed wood oil on the veneer and keeping anything hot or wet off the surface. In a large percentage of cases when we pop the bubbles we notice the bubbles open up right to the bare wood. To see them you have to be on an angle.

Let the glue cure overnight. Inspect the inside of the bubble. Use a scraper to carefully open the paint bubble. What causes bubbles one of the primary causes of bubbles in any kind of finish is moisture in the wood.

This has prompted some painters to theorize that the linseed oil had dried out in the original layers that sit on the wood and when the fresh top coat dries it pulls the old layer away from the substrate. A moisture problem would result in unfinished wood behind the bubble. Bubbles form as the result of a chemical reaction. The bubbles were really subtle.

If you re getting bubbles on your new deck it s probably because your new wood hasn t. Essentially the top layer of paint dries forming a barrier that prevents the solvents from escaping easily. Bubbles caused from a loss of adhesion and lifting of the paint film from the underlying surface. If your siding has been treated with linseed oil in the past prime and paint with oil based products.